Electrical Engineering

Switching Transients Analysis Fundamentals Author: Velimir Lackovic Switching transients severe enough to cause problems in industrial power systems are most

Course number:

EE-04-927

$104

PDH:

4 hours

Shunt Capacitor Bank Design and Protection Basics Author: Velimir Lackovic Shunt capacitor units are typically used to deliver capacitive reactive

Course number:

EE-04-922

$104

PDH:

4 hours

PV Systems Safety Author: Velimir Lackovic This course is intended to be a reference with helpful and easily-accessible instructions on

Course number:

EE-04-921

$104

PDH:

4 hours

Principles of HVDC Transmission Author: Velimir Lackovic Designers must decide between AC and DC transmission. This course addresses this challenge

Course number:

EE-04-920

$104

PDH:

4 hours

Practical Power Cable Ampacity Analysis Author: Velimir Lackovic Cable ampacity studies calculate the current-carrying capacity (ampacity) of power cables in

Course number:

EE-04-919

$104

PDH:

4 hours

Power Quality Measurements – Essential Theory Author: Velimir Lackovic The decline in quality of power is a big issue due

Course number:

EE-04-917

$48

PDH:

4 hours

Overcurrent Protection Fundamentals Author: Velimir Lackovic Protecting relays against high current was the earliest relay protection mechanism developed. From this

Course number:

EE-05-914

$130

PDH:

5 hours

Arc Flash Basics and Hazard Planning Program Author: Velimir Lackovic This course gives an overview of arc flash hazards and

Course number:

EE-03-913

$78

PDH:

3 hours

Arc Flash Calculation Methods Author: Velimir Lackovic This course provides an overview of arc flash hazard computations as specified by

Course number:

EE-05-912

$130

PDH:

5 hours

Limiting Arc Flash Exposure Author: Velimir Lackovic Arc flash incidents may happen despite precautions taken to avert them. Arc flash

Course number:

EE-02-910

$52

PDH:

2 hours

Introduction to Protective Device Coordination Analysis Author: Velimir Lackovic The objective of a protection scheme in a power system is

Course number:

EE-03-909

$78

PDH:

3 hours

Introduction to Motor Starting Analysis Author: Velimir Lackovic The starting current of most AC motors is several times normal full

Course number:

EE-04-908

$104

PDH:

4 hours